ORIMA Sheet metal repair tools

Products containing :
A hot-melt gun, three screw, a nut, a bracket, a hot melt adhesive.

1. with a clean damp cloth to clean dent section.
2. The hot melt glue stick hot melt glue gun is loaded from the back, pull the trigger, let the glue stick into the glue gun, plug in the power, let the glue gun warm up for 5 minutes.
3. Find a suitable traction pads (large dent need big traction pads; (Note: the greater the traction pads, traction tension greater)
. 4. pull the trigger glue gun, glue painted choice extrusion traction pads (4-hole gasket should be painted with hot melt adhesive.
5. Quickly painted hot melt adhesive traction pads on the central portion of the dent, gently press and hold until the hot melt adhesive curing cement; (let the hot melt adhesive to dry for about 8 minutes; we recommend not to let heat melt glue drying time not more than 10 minutes).
6. The traction tension bridge in the middle of the holes in the cement traction spacer bar, the screw rotating knob condom traction gaskets rod, slowly tighten until the dent portion pulled surface is flush with the surrounding can .
7. Some dents, may need to repeat these steps several times to repair the dent.
8. If the repaired surface bulge a bit, follow these steps: First, the thumb rubbing back and forth until the raised points with the other points raised surface as flat; if you can not get with the thumb points raised flat recovery, we must use percussion stick (to hold a pen posture) gently click convex point until the point raised flat. Sometimes you may need to be repeated several times before they can. (Note: When using percussion sticks, can not too hard).
9. dent repair, unscrew the screw rotating knob, remove the traction tension bridge, then remove the traction pads, if hot melt adhesive stick to the surface of the body, so that you can hand gently tear.